AutoPage RemoteStart RS-602
| Remote Start w/ Keyless Entry |
|
Features:
- Two XT-33 Five-button remote transmitter with S.A.W. technology
- Optional XT-11 One-button ultra Mini remote for remote start. Mini remote can be added to factory remote key chain. S.A.W technology
- New Negative and Positive (- & +) Door Lock Outputs
- New Programmable Lock / Unlock pulse times w/ double pulse
- New Negative channel 3 trunk pop output
- New Window-mount super heterodyne SAW receiver. RX-300A
Be sure to check if you vehicle needs a bypass module. You can find out by using this link.
|
Features:
- Two XT-33 Five-button remote transmitter with S.A.W. technology
- Optional XT-11 One-button ultra Mini remote for remote start. Mini remote can be added to factory remote key chain. S.A.W technology
- New Negative and Positive (- & +) Door Lock Outputs
- New Programmable Lock / Unlock pulse times w/ double pulse
- New Negative channel 3 trunk pop output
- New Window-mount super heterodyne SAW receiver. RX-300A
- New Ultra small unit size with Micro K relays
- New Dash mounted LED and Valet switch
- New GM starter timing for no start wire vehicles
- Relays on-board: Parking lights, Starter, Accessory, Ignition #1, Ignition #2
- Output for Ignition #3
- Temporary Stop Feature (short stops with the engine running/no key)
- 200ma ground programmable output for horn or factory security rearm
- Programmable one pulse or three pulse start for adding-on to an existing aftermarket or factory security / keyless entry system (includes programming for shock sensor bypass)
- NEW Programmable factory keyless door locking before & after start
- New Programmable Ignition control door locks (on / off)
- New Programmable Safety Start - Two or One push on the start button
- Programmable for gasoline or diesel engine
- Programmable for remote start: voltage type, RPM/Tachometer learning type or timer checking type
- Programmable Low or High check level
- Programmable run time: 5, 10, 20, or 30 minutes (default=20 minutes)
- Programmable Parking Light output: constant or flashing for visual start confirmation
!
<<
|
|